motionDoorbell: Rings the doorbell when motion is activated.

Set to 0 to disable resetting of motion trigger for MQTT or HTTP.

motionTimeout: The number of seconds after triggering to reset the motion sensor.

See the project site for more detailed instructions. When enabled there will be an additional switch that triggers the motion or doorbell event.

switches: Enables dummy switches to trigger motion and/or doorbell, if either of those are enabled.

This can be triggered with dummy switches, MQTT messages, or via HTTP, depending on what features are enabled in the config.

doorbell: Exposes the doorbell device for this camera.

motion: Exposes the motion sensor for this camera.

If not set, the plugin will grab one frame from source.

stillImageSource: If your camera also provides a URL for a still image, that can be defined here with the same syntax as source.

The most basic form is -i followed by your camera's URL.

source: (Required) FFmpeg options on where to find and how to decode your camera's video stream.name: (Required) Set the camera name for display in the Home app.platform: (Required) Must always be set to Camera-ffmpeg.Manual Configuration Most Important Parameters You may want to check that to see if anyone else has gotten your model of camera working already, or share a configuration setup that works for you. Other users have been sharing configurations that work for them on our GitHub site. Edit config.json manually to add your cameras.Install this plugin using: sudo npm install -g homebridge-camera-ffmpeg -unsafe-perm.It is highly recommended that you use either Homebridge Config UI X or the HOOBS UI to install and configure this plugin. This plugin is supported under both Homebridge and HOOBS.

Homebridge Plugin Providing FFmpeg-based Camera Support Installation

Install ffmpeg homeassistant